48TK3981 wiring diagram. The green wire in back of connector is up. Connect the power wire to a 12 V keyed accessory power source. Modification of wire harness is NOT recommended. Notify Customer Service if modifications are required. 7. Route the 3-wire plug down to the PTO and connect to the solenoid 3-wire plug. Be sure to route away from moving

Read entire manual before starting installation. There is a packet with the PTO which contains 4 WARNING LABELS. Before adhering the labels, make sure the surfaces are free of dirt and grease.

Installation of the Muncie CS6 Series PTO is available for this opening. The installation process for the PTO is the same as the installation on the previous model years with the exception of the wiring.

The 211 x 31' PTO Equipped Caution Label is to be placed within the cab of the vehicle and in easy view of the vehicle operator. It should be located near the PTO control, when the control is installed in the vehicle dash. Fig 2. This label directs the operator to read the PTO operating instructions on the "Visor Label". The Visor Label 4" x 6¾"

SECTION 2 – WIRING DIAGRAMS AND AUXILIARY WIRING INSTRUCTIONS FR66 Electric/Hydraulic Shift System

Route wires and activation lines away from rotating and high temperature com-ponents. Use appropriate looms and bulk head pass-thrus wherever possible to avoid rubbing through insulation or tubing and causing an electrical short or oil leak. Follow all Federal Motor Vehicle Safety Standards (FMVSS) for your vehicle.

Read entire manual before starting installation. There is a packet with the PTO which contains 4 WARNING LABELS. Before adhering the labels, make sure the surfaces are free of dirt and grease. Place the labels supplied as follows:

Read entire manual before starting installation. 1. There is a packet with the PTO which contains 4 WARNING LABELS. Before adhering the labels, make sure the surfaces are free of dirt and grease.

Locate bluntcut body builder wires provided by Ford as described in this supplement. E. Follow the diagrams for your vehicle engine type and operation mode. Changes to the vehicle SEIC wiring were made in the 2017 model year beginning Sept. 2016. This supplement adapts the Muncie wiring harnesses to these vehicles.

Muncie Power Products, Inc. FR SeRieS pto Parts list and service manual Muncie Power Products, inc. FR63/FR64 SeRieS pto exploded view. FR63 Bearing Removal Location. FR64 Bearing ... 13 1 See Wiring Harness Chart Below 15 1 37T35674 Rubber Grommet 17 1 43T36231 Tee Fitting N.S. 2 19T36623 Cap Screw, Solenoid Mtg. ...